Four lifespans currently affecting the life of pogo pin

　　The pogo pin is a spring-type probe formed by the three basic components of a needle (Plunger), a needle tube (Tube) and a spring (Spring) after riveting by a precision instrument. It is also called a pogo pin, a pogo pin, and a spring probe. Pin, Spring? Loaded, PogoPin connector.

　　Spring thimble working stroke selection:

　　When choosing a spring thimble, it must be based on the space of the product used, and choose the one within the working stroke range; too small space will over-compress the spring of the spring thimble and affect the service life. If the space is too large, it may cause insufficient contact. , The impedance is unstable and the transient phenomenon appears.

　　Selection of electroplating materials:

　　Electroplating materials have the functions of increasing conductivity, preventing oxidation, and anti-wear in the spring thimble. Different materials have different functions. For example, gold has good conductivity. For high-current connectors, products with high impedance requirements are general Will choose electroplating gold.

　　What are the effects of plating film thickness on spring thimble:

　　The spring thimble will have a certain amount of friction when it is working, and it will be worn after a long time. The thickness of the electroplating film will have a great impact on the service life of the product. When used to a certain limit, the electroplating layer will be worn away. There may be phenomena such as excessive resistance and unstable impedance. The electroplating layer of the 100,000-times spring thimble must be thicker than that of the 10,000-times spring thimble, so please be sure to choose the plating film thickness requirements according to your needs when selecting the product.

Read recommendations:

Receiving signal thimble

Electronic spring contacts M631 3.89X17.15

Electronic spring contacts M693 1.4X2.3

Electroplating treatment of pogo pin connector parts!Through Hole Pogo Pin Production

Can pogopin pogo pins be used on industrial robots (manipulator quick-change devices)?