What are the main methods of maintaining precision pogo pins?

　　Maintenance is required for precision pogo pins. Routine maintenance can ensure the normal operation of the machine and reduce the failure rate. So today, Chuangda Gaoxin will tell you about the maintenance methods of precision pogo pins.

　　Among them, the maintenance content of the pogo pin machine (computer pogo pin machine, computer spring coiling machine) only needs to be clean, tightened, adjusted, lubricated, and anti-corrosion. In order to reduce the wear speed of the mechanical parts of the pogo pin, eliminate long-term hidden troubles, and prolong the service life of the machine, the Suzhou pogo pin manufacturer needs to do the following work:

　　1. Routine maintenance. Routine maintenance is centered on cleaning, tightening, adjustment and lubrication. Routine maintenance of the pogo pin machine should be carried out as required before each shift, during work and after closing the car. This task is performed independently by the pogo pin mechanical operator.

　　Second, regular maintenance. According to the maintenance requirements of various mechanical equipment, after reaching the specified working hours or specified mileage, corresponding regular maintenance must be carried out, including the following:

　　First-level maintenance: First-level maintenance is carried out on the basis of routine maintenance, and the key work is to lubricate, tighten and check that all relevant parts have been cleaned and the three-filter work (air, oil, fuel filter). It is mainly guided by the mechanical team leader and completed by mechanical operators.

　　Secondary maintenance: The secondary maintenance mainly focuses on inspection and adjustment. Specifically, check the working conditions of the engine, clutch, transmission, etc. and make necessary adjustments to eliminate the faults found. Ensure that the pogo pin machinery has good working performance. The secondary maintenance is completed by the mechanical operator with the assistance of the warranty personnel.

　　Three-level maintenance: focus on detection, adjustment, and troubleshooting. It is necessary to carry out diagnostic inspection on the parts that affect the performance, and then complete the necessary replacement, adjustment and troubleshooting to create a pogo pin machine. Tips: In addition to these maintenance methods, the computer pogo pin machine,

　　Also, be careful not to use a large number of pogo pins with overloaded wire diameters, which will be very detrimental to the maintenance of the pogo pin machine and will reduce the lifespan. Don't use the new machine as a novice to adjust the machine to practice.

Read recommendations:

Spring contact pin M029 1.8x14.5

M1463 4.00x12.20(1A)

M1131 2.00x6.10(1A)

Analyze the composition of pogopin

How to choose the size of the board-to-board connector?