How to treat the main specifications of RF coaxial connectors

　　I don't know how much you know about the main specifications of RF connectors. As a practitioner and purchaser in the electronic components industry, it is necessary to understand some basic knowledge of RF connector specifications. Generally speaking, how to evaluate the main specifications of RF connectors?

　　Impedance: Almost all RF connectors and cables are standardized to 50Ω impedance. The only exception is that 75Ω systems are commonly used in cable TV installations. It is also important that the RF coaxial cable connector has a matching characteristic impedance of the cable. If this is not the case, a discontinuity is introduced and loss may result.

　　VSWR (Voltage Standing Wave Ratio): Ideally, it should be unity. Good design and implementation can keep VSWR below 1.2 within the range of interest.

　　Frequency range: Now most of the radio frequency work is in the range of 1 to 10GHz, therefore, the connector must have low loss in this area. For the case above 10 GHz-there is a lot of work, and now things in the 10 to 40 GHz range-there are newer connectors among them to choose. They are expensive because of the cable itself.

　　Insertion loss: This is the connector loss in the frequency range of interest. The loss is usually between 0.1 and 0.3 decibels. Determining how critical per watt (or fractional watt) is in most designs, even such a small loss must be minimized and included in the link loss budget. It is in the low-noise front end, especially when the signal strength and signal-to-noise ratio are low.

　　Operation cycle: How many connection/disconnection cycles can be connected and still meet its specifications? This is usually 500 or 1000 cycles. For threaded connectors, the tightening torque specified by the supplier is an important factor in maintaining performance and reliability.

　　Power: Power handling is determined by two resistance losses (heating) and insulation breakdown. Although even decades of design are mainly pre-processing tens of watts, today's design community focuses on low-power devices such as mobile phones, picocells and femtocell base stations, video interfaces, RF and gadgets. These are in the sub 1W range, so the connector can be much smaller and its rated power is a smaller constraint

Read recommendations:

M2136 2.0x4.6(1A)

M2401 2.4x7.7(1A)Water level spring pin company

M555 4.5X21

How does pogo pin work?

The importance of round hole pin headers!pogopin price